For my bicycle, I have the three seperate parts and I'm not sure what to do with all of them.
Ok--that is hard to describe here. Go to this link, read it and check out the illustrations. Good Luck. http://www.parktool.com/repair/...
A 3-pc link is made up of the link with pins, another plate, and the snaplock plate thingy. If you need to take out part of an existing chainlink so that you have two female ends, then get your chain tool out. To use the master link, put the pins through each hole in the chainlink ends, then put on the solid plate, and snap on the locking one. You might need some pliers to get it on (probably will). There are lots of different links on the market, but it sounds like this is what you have.
|
