please explain step by step I know nothing about repairing bikes I'm trying to learn. Thank you.
remove the inspection plate on the bottom of the trannsmision,get an empty pepsy bottle fill about half full. you will need a small rubber hose and another person to pumpthe clutch. always keep an eye and the resevoire.inside the inspectin plate you will see a thin that looks like a grease zerk,loosen it {don't remove it}. put the hose on the end of the zerk. put the other end of the hose in the bottle. make sure you dont suck air in the systemor you will have to do it all over again. pump the clutch ,checking the clutch every little bit. when you check the clutch for proper adjust ment make sure you tighten the zerk. its close to the same procedure as bleeding youre brakes.
I suggest you use a MightyVac. Its a reverse cup gun that pulls vacuum on the bleeder. Air cannot get back in, just watch the master cyl. Brakes and clutch can be done by one person.
I ride.
|
