| Bike Pedals |
| Why can you exert greater force on the pedals of a bicycle if you pull on the handlebars? |
|
because the muscles in your arms pulling on the handle bars causes an equal and opposite reaction from the bars acting on your arms in a dir...... |
| How much does a set of average bicycle tires cost? pedals? |
|
yea u can get em at wallymart and all....prolyl spend like 15 bucks on tires and 20 or so on pedals...dont bother gettin new **** tho, save ...... |
| My bicycle pedals only turn backwards, which is not much use. What could be wrong (that I could fix myself)? |
|
Sounds like the rear derailleur is getting in the way of progress. If you can't diagnose it yourself, chances are, you probably can'...... |
| How do I fix the clicking noise my bicycle pedals make? |
|
Either your pedal bearing or your bottom bracket bearing needs adjustment. It sounds like the bearings are loose, and what happens is that ...... |
| Bicycle pedals or crank case? what? |
|
It's called the bottom bracket, but I caution you, if you don't know what you're doing it would be better to take it to your tru...... |
| Bicycle's design? |
|
do you mean you can turn the pedals backwards, but if you push it forewards it will drive the wheels?
this is true in other than track bi...... |
| Does anyone have any information on a harley davidson pedal bicycle made by roadmaster called nighthawk? |
|
did you try Ebay?? Try their and see...... |
| When you pedal a bicycle, maximum torque is produced when the pedal sprocket arms are in the horizontal positi |
|
When the pedal sprocket arms are in the horizontal position,the foot applies a force perpendicular to it.(vertically downward) and this is m...... |
| What is the standard thread size on a bicycle pedal? |
|
If you have three piece cranks it is 9/16,if your cranks are 1 piece then it is 1/2. These are the only two sizes used in the industry.9/16 ...... |
| How do you take off a bicycle PEDAL?????????? i know it untwist but its too tight...any tips how to get itoff? |
|
First off remember that the left pedal has a left hand thread and the right pedal has a right hand thread!
Try some WD40. Clamp or tie th...... |
| Amount of time it would take for a suspended bicycle wheel to spin after a specified force is applied.? |
|
Adam is right (provided the wheel is well balanced!)
In addition to mass, you also need to know the mass distribution.
e.g.; if the wh...... |
| Bicycle pedal stress analysis HELP!!? |
|
If you're talking about sheer and normal stress, than you should start by cutting the bolt holding the arm to the pedal. On this there i...... |
| What are the risks using clipless pedals on a racing bicycle? |
|
Overall, using clipless pedals are much safer than the older toe clip pedals (does anyone even remember riding with them?). With toe clips,...... |
| Why can you exert a greater force on the pedals of a bicycle if you pull up on the handle bars? |
|
because when you normally pedal you are just distributing the force of your weight from side to side, where as by pulling the handle bars yo...... |
| Do your Abs get a workout of any kind while pedalling a Bicycle? |
|
yes the cardio is the best for extra tummy and one of the only things that will get you a six pack...... |
| Will I get a speeding ticket if I pedal my bicycle above the speed limit? |
|
It depends if ur on the road but i doubt u will be able to thts stupid ?Yep.
Cyclists are subject to the same laws as motorists.I've...... |
| Which Scottish blacksmith invented the first pedal driven bicycle? |
|
You're no doubt referring to Kirkpatrick Macmillan but that's subject to considerable questioning in bicycle history circles, except...... |
| Who was the first man to pedal a bicycle around the world? |
|
Thomas Stevens!...... |
| Pedal a bicycle using your hands and feet. Who can build one ? How to steer ? |
|
I could not find any sites on it, maybe after you find out how to do this you should make a site for it. Sounds hard but it also sounds like...... |
| What to do to a bicycle to make it easier to peddal? |
|
1. Check to make sure that the wheels spin freely. Are the brakes rubbing against the tires? Are the brakes retracting after they are used? ...... |
| Im doing some research on bicycle's pedaling-loss and iam very grateful if anyone here can share about it.pls |
|
The most obvious is simply to get a feel for forward pressure. To get a good feel for this while moving, try the pedaling with one leg drill...... |
| Do they sell bicycles with pedals and engines on them? |
|
It is called a moped.
Source(s):
...... |
| How can I safely remove a right-hand pedal from a new bicycle? |
|
Normally the righthand side threads are righthand. This is the way I do it. Facing the bike with the front wheel to the right, turn the cran...... |
| Is there a way to repair a stripped pedal mount on a bicycle crank arm? Or do I need to replace the crank arm? |
|
If your pedal mount is stripped out, then you will have to replace it. Even if the pedal still threads into the crank, any loosness will qu...... |
| Why do you have to push harder on the pedals of certain bikes? |
|
Its in the ratio of the gear on the pedal to the gear on the wheel. A single speed bike is going to try and achieve a balance of attaining ...... |
| Page:9 Previous-5-6-7-8-9-10-11-12-13-14-Next |
