|
|
| *Vultures Knob>>>Bike Lights |
Is it a big job? |
i need to check my solanoid and starter motor on my bike (fazer 600) because it wont start,it makes a load clicking noise when i try to start it, i dont think its the battery because the lights work fine and basically i havent a clue where to start .......can anyone help ? OK heres the deal, first you have to make sure the battery is good. Take it out and charge it, or take it to a bike shop and have them charge it, they will also be able to load test it for you. I suspect that a weak battery is your problem. OK now that the battery is taken care of if it still doesn't start and just clicks you have to test the solenoid. Follow the large red battery cable to the solenoid, use and old screwdriver or pliers to jump accross the two large terminals on the solenoid. If the starter is OK the engine will turn over (note: you don't even have to have the key on and make sure the bike is in neutral before you try this). If the engine turns like this you have a bad solenoid. If the engine does not turn over you have a bad starter motor...or...something is wrong with the engine itself. Any other questions feel free to ask. take the cables off clean them check the battery ,it takes alot more power to start a bike than it does for lights A loud clicking noise is usually because either your battery is low in power or the solenoid is not functioning properly. If you know what, or how, to do it, you can bypass some/all of the starting routes (Wires) for current and simply use a jumper cable to test the starter motor, but if you are not sure of what you are doing DON'T TRY IT. experience the loud click IS the solenoid, the click is a good sign. Remove sidepanel (or whatever fazer has) and find the solenoid, switch ignition on MAKE SURE BIKE IS IN NEUTRAL. Short a spanner across the two nuts on top of the solenoid, if the starter turns and the engine starts, replace the solenoid, if you still just get a click check the starter motor itself. Solenoid for a mini will cost less than a tenner and work just fine. its probably just the brushes in the starter that have worn, geo46er has it right as do most of the others, if the solenoid clacks when you push the start button the chances are that the battery is not fully charged or is defective.A battery will run lights down to about 30% of it's capacity but needs about 85% of it's capacity to turn the starter motor.I would suggest you bench charge the battery or try to start the bike using another vehicle and some heavy Duty (10 mm or larger) jump leads |
| Tags |
| Bike Tours Trail Map Bike Pedals Bike Lock Bike Lights Bike Helmet Quad Bike Pocket Bike Mini Bike |
Bike Categories--Copyright/IP Policy--Contact Webmaster |